
- A safety switch (RCD) cuts the power in a fraction of a second when current leaks to earth. Tripping means it is doing its job.
- The usual causes: a faulty appliance, moisture in an outdoor fitting, or a wiring fault.
- Unplug everything on that circuit, reset, then plug things back one at a time.
- If it trips with nothing plugged in, or trips again straight away, call us.
What a safety switch does
A safety switch watches the current going out and coming back on a circuit. If some of it leaks to earth, through a damaged cable or a person, the switch cuts the power in milliseconds. A circuit breaker protects the wiring from overload; a safety switch protects people. Many modern boards combine both in one device.
NSW recommends testing yours at least every six months: press the T button, the power should drop, then reset it.
The usual causes
- A faulty appliance. Old fridges, heaters, kettles and anything with a damaged cord are the common ones.
- Moisture. Outdoor power points, garden lights and bathroom fittings after rain.
- A wiring fault. A nail through a cable, rodent damage, or a worn-out fitting.
- Too much on one safety switch. Older boards often have one switch covering many circuits, so small leaks add up.
What to do first
Switch off and unplug everything on the circuit that tripped. Reset the safety switch. If it holds, plug appliances back in one at a time; the one that trips it is the faulty one. If it trips with nothing plugged in, or will not reset, stop there and call us. Do not keep resetting it.
What we do
We find the fault with test equipment rather than guesswork, repair or replace what caused it, and if the board has one safety switch doing too much we quote splitting the circuits so one wet garden light does not take out the fridge.
